Next, vacuum and steam along baseboards, window sills, and the edge of the carpet. When you’re done vacuuming, the bag or canister should be cleaned or discarded to limit exposure of bed bugs to other parts of the home. The steamer can also be used to treat sofas, chairs, furniture, and cabinets. When applying steam, remember to move the nozzle slowly (about one inch per second) to ensure that all bed bugs and eggs are killed.
Quote: Similarly, bed bugs will perish in extremely cold temperatures. If it is possible to keep a room unheated for a prolonged period of time, it may kill the population. All stages of the common bed bug, from nymphs to adults, can survive for up to five days in temperatures of fourteen degrees Fahrenheit. Prolonged exposure, however, to these temperatures, will kill them.
Pay attention to when the bites occur. Consider, for example, if you notice the bites after waking up when previously you hadn't noticed them. However, this can also be difficult to determine because each person's reaction time can vary significantly. Symptoms that result from the bite can manifest at any point from a couple of hours to more than a week after the bite occurred.
As soon as you determine you have bedbugs, isolate clothing, and start putting them into clean plastic bags. Accuracy is very important, so pinpoint the areas and rooms that need treatment and act swiftly. While some people think over-the-counter sprays are a solution, pyrethroid-based pesticides may kill or repel some of the insects, but can be dangerous if misused, and it's doubtful you'll be successful on your own.
Unlike those of other insects, bed bug bites may sometimes appear in tight lines of multiple, small, red marks where multiple bed bugs have fed along an exposed area. Bed bug bites can cause itchiness. Initially, a victim may detect a slight burning sensation. The burning area then develops red bumps, known as papules or wheals (rash). In extreme cases, bites may swell dramatically or turn into blister-like skin inflammations.
Bed bugs occur around the world.[36] Before the 1950s about 30% of houses in the United States had bedbugs.[2] Rates of infestations in developed countries, while decreasing from the 1930s to the 1980s, have increased dramatically since the 1980s.[3][4][36] Before the 1980s they were common in the developing world but rare in the developed world.[4] The increase in the developed world may have been caused by increased international travel, resistance to insecticides, and the use of new pest-control methods that do not affect bed bugs.[37]
With practice and a flashlight, nonprofessionals can become proficient in finding and destroying bed bugs. The process is made easier by reducing clutter, especially in bedrooms and sleeping areas. Bugs that are spotted can be removed with a vacuum (see previous discussion), or killed with over-the-counter insecticides labeled for such use. Most bed bug sprays intended for householders have little remaining effect after the spray has dried. Therefore it’s important to initially contact as many of the insects as possible with the spray droplets. Insecticide labels should be read carefully as some bed bug products should not be used on mattresses and seating areas. Some insecticides applied as powders or dusts (e.g., diatomaceous earth) will kill bed bugs although boric acid powder will not. However powders can be messy and difficult to apply, especially by nonprofessionals. Total release foggers (otherwise known as ‘bug bombs’) are ineffective against bed bugs and potentially dangerous when used incorrectly (see University of Kentucky entomology fact sheet Limitations of Home Insect Foggers).
Bed bugs have been pestering humanity for thousands of years, but in the 1950s they finally met their match: the pesticide DDT. Then DDT was banned, but for most of the 40 years since, bed bugs have not been a major problem. Now, however, these blood-sucking vermin are back with a vengeance. That’s the bad news. The good news is that, unlike mosquitoes and ticks, bed bugs don’t spread disease, and there are practical steps you can take to prevent an infestation. And if you do get bed bugs, you can get rid of them yourself. We’ll show you what to look for, how do you get rid of bed bugs if you find them, and how to keep them out!
Kept replacing the sticky traps just in case but never caught anything other than the occasional spider. Always cycled the sheets and such using the car+sun. They were still getting to us. Bed bugs cannot fly or jump. They had to be in the bed frame. I check it over and notice rusty spotting, which is apparently bed bug fecal matter. Luckily ours was from IKEA so it was easy to take apart – and sure enough – there they were. The way my bed works is a metal frame with holes, rubber end caps fit into those holes, and wooden slats run across the frame in the end caps. So every few days I’d mix up a 50/50 mix of bleach and water in a bucket and soak the wooden slats and end caps for ten minutes. The bed bugs were gone a couple of weeks and came back. I started soaking the things longer and scraping them with a disposable spoon, which was hard to do on the end caps. It warped the wood a little but nothing too bad. After a couple of weeks or so, I stopped finding bed bugs in the frame. I was worried they were in the metal too, but I completely stopped getting bites. I think the added time and scraping got rid of eggs. Not a lot can survive a 30 minute bleach bath.

Spectre 2 SC has a low odor and is not dectectable by the bed bugs. Adjust the spray pattern to a mist by turning the nozzle. A low fine mist is best for most spraying, but you may need to use a stream to get into some cracks and crevices. If you can't get into the cracks and crevices use one of the aerosols described below with it's crack and crevice tips to reach into these areas.


Use a Hand Bellow Duster to apply dusts into the cracks and crevices with the Cimexa Dust. Put dust into duster. Remove switch plates and electrical outlet covers and dust into the openings. Another tool used for dusting would be a small paint brush or small makeup brush. Apply a small amount of dust on the tip of the brush, brushing into cracks and crevices. Dust any items hanging on the wall such as pictures with a small paint brush. Use a small paint brush to paint dust in seams and around buttons of mattress. Use dust or aerosol in all joints of the bed frame.


Bed bugs have six life stages from eggs to adulthood. The adults and nymphs of the pests could stay out of sight for months after feeding so they are quite difficult to detect. However, the eggs are much harder to locate. Female bed bugs usually hide them in dark and deep cracks and crevices. The fact that they are very small, makes it even harder to search for them. So, if you need to implement a keen inspection when looking for adult bed bugs, you need to be more canny when looking for their eggs.

You may be tempted to take treatment into your own hands. The nonchemical treatment options — such as heating and freezing — can help reduce the number of bedbugs you’re dealing with but probably won’t get rid of the population completely. Eggs and young bedbugs can be incredibly difficult to locate since they can be small enough to fit inside the head of a screw, Lazarus says.
Kept replacing the sticky traps just in case but never caught anything other than the occasional spider. Always cycled the sheets and such using the car+sun. They were still getting to us. Bed bugs cannot fly or jump. They had to be in the bed frame. I check it over and notice rusty spotting, which is apparently bed bug fecal matter. Luckily ours was from IKEA so it was easy to take apart – and sure enough – there they were. The way my bed works is a metal frame with holes, rubber end caps fit into those holes, and wooden slats run across the frame in the end caps. So every few days I’d mix up a 50/50 mix of bleach and water in a bucket and soak the wooden slats and end caps for ten minutes. The bed bugs were gone a couple of weeks and came back. I started soaking the things longer and scraping them with a disposable spoon, which was hard to do on the end caps. It warped the wood a little but nothing too bad. After a couple of weeks or so, I stopped finding bed bugs in the frame. I was worried they were in the metal too, but I completely stopped getting bites. I think the added time and scraping got rid of eggs. Not a lot can survive a 30 minute bleach bath.
Scrub infested surfaces with a stiff brush to dislodge eggs. Vacuum the room extensively. Use a vacuum hose attachment to thoroughly vacuum cracks and crevices on furniture and along baseboards on the walls. Vacuum along baseboards, furniture, bed stands, rails, headboards, foot boards, bed seams, tufts, buttons, edges of the bedding, as well as the edges of the carpets (particularly along the tack strips). A good vacuum cleaning job may remove particles from cracks and crevices to encourage greater insecticide penetration. Bed bugs cling tightly to surfaces, so it is best to vacuum by scraping the end of the vacuum attachment over the infested areas to pull out the bed bugs. Caution: It is not good to use a bristle attachment, because you may transfer bed bugs to other areas since they cling to the brush. Dispose of vacuum cleaner bags after you are finished in an outdoor trashcan.

Minimize its spread. First, notify your landlord if you rent in a building to control its spread to other units. Thoroughly vacuum any infested areas, including carpets and mattresses, and then empty the vacuum bag into a plastic bag, seal it, and throw it in the trash outside. If you can’t get the bed bugs out of your furniture, discard items in a responsible manner. To avoid someone else from salvaging infested furniture or mattreses, rip, remove stuffing, or spray paint with the words “bed bugs.”

When professionals need to treat an infestation, they don’t reach for rubbing alcohol or cedar oil or a blow dryer. They use a proven treatment process that involves a combination of proven products to get the job done. It’s not about whether or not a certain item can kill bed bugs, it’s about whether that item is the ideal part of a treatment that will actually get rid of an infestation. After all, your shoe would have a 100% kill rate on any bed bugs you smack with it – that doesn’t mean you can expect to be bed bug free after a diligent afternoon of shoe-wielding.

In the case of beds, a more economical option is to encase both the mattress and box spring in a protective cover like those used for allergy relief. Encasements specifically designed to help protect against bed bugs are available through retail or pest control firms. Higher quality ones tend to be more durable and comfortable to sleep on. Once the encasement is installed and zipped shut, any bugs which happen to be inside are entombed and eventually will die. Encasements also help protect newly purchased beds, and make it easier to spot and destroy any bugs residing on the outer surface during subsequent examination. Encasements will not, however, keep bed bugs from crawling onto a bed and biting a sleeping person.
Next, vacuum and steam along baseboards, window sills, and the edge of the carpet. When you’re done vacuuming, the bag or canister should be cleaned or discarded to limit exposure of bed bugs to other parts of the home. The steamer can also be used to treat sofas, chairs, furniture, and cabinets. When applying steam, remember to move the nozzle slowly (about one inch per second) to ensure that all bed bugs and eggs are killed.
If you think that by discarding the whole bed means getting rid of bed bugs, you are wrong. By moving the mattress and the bed frame, you not only risk moving the bed bugs all around the house, you are also missing out on many other spots these bed bugs could be at. For example, curtains, floor panels and skirting or even the door frames are able to hide these bed bugs very well. The root causes of the infestation must be eradicated fully.
Discard affected items. In some cases, infested mattresses and box springs will need to be discarded. Since bed bugs can disperse throughout a building, it also may be necessary to inspect adjoining rooms and apartments. Pay it forward: chop up and/or damage the items you discard so nobody will be tempted to take them home and spread the problem further.[17]
Amazingly, these sneaky little bloodsuckers dine on you without waking you. You don't feel their stealthy bite because they inject a numbing agent into your body, along with an anticoagulant to keep your blood flowing as they suck. The first sign of bedbugs may be itchy, red bites on the skin, usually on the arms or shoulders. Bedbugs tend to leave straight rows of bites.
To use heat or not to heat? While not always successful, there are other methods of bed bug control. For example, using heat above 98 F is lethal to bed bugs. This type of treatment should usually be peformed by an experienced company since great damage can be done to walls, furniture, flooring, etc, not to mention that you need the proper equipment to be able to perform it. If you are interested in hiring a company to perform a heat treatment, contact us for recommendations for companies in your area.
Inspection requires knowledge, dedication and time. At minimum an inspection should involve a detailed examination of mattresses, box springs and bed frames, as well as likely hiding places for bed bugs within 20 feet of beds and other places where residents may sleep or rest, e.g., on couches). Clutter-free space will be needed to allow furnishings to be moved and manipulated for inspection. In general, rooms with more furnishings will take more time to inspect.
Bed bugs were mentioned in ancient Greece as early as 400 BC, and were later mentioned by Aristotle. Pliny's Natural History, first published circa AD 77 in Rome, claimed bed bugs had medicinal value in treating ailments such as snake bites and ear infections. (Belief in the medicinal use of bed bugs persisted until at least the 18th century, when Guettard recommended their use in the treatment of hysteria.[51])
×