Other types of bed bug traps include those that do not rely on humans as bait, but instead use CO2and/or other attractants. CO2 is thus far the most powerful lure for bed bugs, as it is the primary cue they follow to locate hosts. Traps that issue CO2 for a period of time are more expensive than Climbup™ traps, but can effectively trap bed bugs when no host is present, such as in common areas, vacant homes or units, offices, schools, and theaters. Thus they can help confirm infestation and eradication.
It was stated in 2012 that no truly effective insecticides were available.[6] Insecticides that have historically been found effective include pyrethroids, dichlorvos, and malathion.[4] Resistance to pesticides has increased significantly over time, and harm to health from their use is of concern.[3] The carbamate insecticide propoxur is highly toxic to bed bugs, but it has potential toxicity to children exposed to it, and the US Environmental Protection Agency has been reluctant to approve it for indoor use.[33] Boric acid, occasionally applied as a safe indoor insecticide, is not effective against bed bugs[34] because they do not groom.[35]
Flat surfaces can be wiped with alcohol or sprayed with a bed bug—killing contact pesticide, but all items that have a small nook or cranny where bed bugs could hide (which is most stuff) need to be treated with penetrating fumes. Build yourself a kill chamber out of a large storage bin. Tape a pesticide strip to the side or lid of the bin, and seal your stuff inside for a couple days or however long the manufacturer recommends. Seal the lid of the bin with duct tape.
While alcohol can kill bed bugs on contact, it’s not going to kill nearly enough of bed bugs to be considered effective. In lab studies, even 99 percent concentrations of alcohol only killed between 40% to 60% of the adults that were sprayed. On top of that, alcohol has no long-lasting residual effect, and doesn’t affect bed bug eggs. 60% sounds good, but a contact killer should be able to kill a lot closer to 100% of the bed bugs you see. Otherwise, a shoe or a blowtorch would be the more reliable tool for the job. (Editor’s note: please don’t use a blowtorch.)
Great read and very helpful info. However, when you describe how to use essential oil sprays for bed bug treatment, it would be most helpful if you included the amount of water used to mix with the oils. Simply stating to use “a small spray bottle filled with water” isn’t a very good description. A quick search for “small spray bottle” will get results for a wide range from 2-ml to 16-ounce bottles, all classified as small. This makes for a rather potent mixture to an extremely weak mixture.
DIY bed bug sprays are mostly ineffective in dealing with a large bed bug infestation. This is because a do-it-yourself method lacks proper knowledge on pest behavior to fully control the infestation. For example, bed bugs are real flat and tiny; they hide very well at unexpected places which you may not know. A pest control professional is able to identify key hotspots to treat effectively.
Start in the corners and along edges of an open wall.  With the card, see if you can dig things out of the cracks and crevices. Work your way along the cracks and crevices. For example, if you are checking a baseboard along the floor, see if you can get the card between the baseboard and the floor, as well as the top of the baseboard and the wall. If you have a bare tile or wood floor, consider using a damp cloth or map to wipe the floor.  Don’t use too much water as floors can be slippery.  Look for anything moving after you wipe the floor. If you have carpeted areas vacuum the clean area. See Vacuuming Items to Capture Bed Bugs.  Don’t forget to check pictures and other items on this wall.
Bed bugs multiply quickly, and in just six months, a few can turn into a full-on infestation of 13,000 or more. Detection is critical to break the bed bug life cycle before they become a bigger problem. Orkin Bed Bug Detection Service gets to the root of the problem with targeted inspections of common bed bug hiding places in your home and ongoing monitoring to ensure the pests never return.
Heat Treatment – this method kills bed bugs with heat. This could be implemented on clothes by putting them in a drier at a high temperature for 30 minutes. In a room, the use of heating devices could kill even the eggs and the nymphs of bed bugs at certain levels temperature at different durations of time. Ideally, to kill bed bugs in all stages, the temperature must be 115 degrees F or 46 degrees C.

Wash the bites with soap and water. Wash the area with mild soap and water; use a bar of soap and enough water to wet surface of your hands. Work the soap in your hands into thick, soapy lather. Rub the lather over the affected area liberally. Repeat until the entire area is covered. Leave on and do not rinse. Allow the soap lather to dry over the bitten areas. You should experience immediate relief from itching.[5]
Systematically treat the room–all cracks and crevices around windows, outlets, blinds, pictures, posters and clocks on walls, baseboards, under edges of carpets and any other crevices or void areas in the room. Remember that immature bed bugs are very tiny. Dozens of bed bugs can hide in a recessed screw hole in a bed frame or dresser. Therefore it’s important that no hiding place be overlooked. Treatment can include vacuuming, but should not be limited to vacuuming only. Vacuums do not remove eggs, and will likely not remove all bed bugs from deeply infested cracks and crevices. Vacuums can remove many bed bugs from mattresses and the exterior of box springs (remember to immediately double-bag the vacuum bag after cleaning and dispose of outside in a trash can or dumpster). Sticky tape is another method of picking up bed bugs from furniture, walls, etc.
Bed bugs are experts at hiding. Their slim flat bodies allow them to fit into the smallest of spaces and stay there for long periods of time, even without a blood meal. Bed bugs are usually transported from place to place as people travel. The bed bugs travel in the seams and folds of luggage, overnight bags, folded clothes, bedding, furniture, and anywhere else where they can hide. Most people do not realize they are transporting stow-away bed bugs as they travel from location to location, infecting areas as they travel.
While alcohol can kill bed bugs on contact, it’s not going to kill nearly enough of bed bugs to be considered effective. In lab studies, even 99 percent concentrations of alcohol only killed between 40% to 60% of the adults that were sprayed. On top of that, alcohol has no long-lasting residual effect, and doesn’t affect bed bug eggs. 60% sounds good, but a contact killer should be able to kill a lot closer to 100% of the bed bugs you see. Otherwise, a shoe or a blowtorch would be the more reliable tool for the job. (Editor’s note: please don’t use a blowtorch.)

Avoiding bed bugs is most challenging in hotels, apartment buildings, and other places where there are many people, high turnover and ongoing opportunities for introduction of the pests. Periodic, preventive inspection by tenants, housekeeping/maintenance staff, or pest control firms is the best way to detect infestations in their initial stages when they are easiest to control. Visual inspections can be supplemented by using various monitoring devices to capture and reveal bed bugs that may have been overlooked by occupants.   
Inspection requires knowledge, dedication and time. At minimum an inspection should involve a detailed examination of mattresses, box springs and bed frames, as well as likely hiding places for bed bugs within 20 feet of beds and other places where residents may sleep or rest, e.g., on couches). Clutter-free space will be needed to allow furnishings to be moved and manipulated for inspection. In general, rooms with more furnishings will take more time to inspect.
Inspection requires knowledge, dedication and time. At minimum an inspection should involve a detailed examination of mattresses, box springs and bed frames, as well as likely hiding places for bed bugs within 20 feet of beds and other places where residents may sleep or rest, e.g., on couches). Clutter-free space will be needed to allow furnishings to be moved and manipulated for inspection. In general, rooms with more furnishings will take more time to inspect.

Reactions to bed bug bites vary among individuals. Many persons show no signs of bites. Others don’t realize they’ve been bitten until redness and swelling appear around the bite, sometimes with intense itching. Some exhibit inflamed swollen spots that may occur in linear series or have a rash-like appearance. Such bite marks, when they appear, may not show for several days after the person is bitten.

×