The likelihood of bed bugs increases if the affected individual has been traveling, or if they have acquired used beds or furnishings before symptoms started to appear. Bed bugs also are suspect if you wake up with itchy welts you did not have when you went to sleep. It’s important to recognize, however, that not all bite-like reactions are due to bed bugs. Confirmation requires finding and identifying the bed bugs, shed skins, fecal spots, etc., which often requires the help of a professional. (Other possible sources of irritation that may be mistaken for bed bugs are discussed in University of Kentucky entomology fact sheet ENT-58, Invisible Itches: Insect and Non-Insect Causes). 
CrossFire Bed Bug Concentrate has two different active ingredients for dual modes of action (both a quick kill and residual activity). Mix 3 oz of CrossFire Insecticide with one gallon of water or 0.75 oz per quart (Remember to use what you mix-within 24 hours.) Adjust the spray pattern to a mist by turning the nozzle. A low fine mist is best for most spraying, but you may need to use a stream to get into some cracks and crevices. If you can't get into the cracks and crevices use one of the aerosols described below with it's crack and crevice tips to reach into these areas.
DIY heat treatments most often just drive bed bugs deep into wall voids and hard-to-reach spaces in a structure. When the heat is turned off, the bugs return to living and sleeping areas. It has no impact at all. But, in worst case scenarios, where desperate people have gone to greater lengths to destroy these tormenting pests, it has resulted in damage to belongings, the death of pets, structural fires, and in tragic cases, a loss of human life.

Flat surfaces can be wiped with alcohol or sprayed with a bed bug—killing contact pesticide, but all items that have a small nook or cranny where bed bugs could hide (which is most stuff) need to be treated with penetrating fumes. Build yourself a kill chamber out of a large storage bin. Tape a pesticide strip to the side or lid of the bin, and seal your stuff inside for a couple days or however long the manufacturer recommends. Seal the lid of the bin with duct tape.
Other types of bed bug traps include those that do not rely on humans as bait, but instead use CO2and/or other attractants. CO2 is thus far the most powerful lure for bed bugs, as it is the primary cue they follow to locate hosts. Traps that issue CO2 for a period of time are more expensive than Climbup™ traps, but can effectively trap bed bugs when no host is present, such as in common areas, vacant homes or units, offices, schools, and theaters. Thus they can help confirm infestation and eradication.
Bed bugs could be hiding in all sorts of tight spaces in your room, like wood cracks, inside books and furniture, and along the baseboards and the edges of the carpet. In this step, we’re going to clean, vacuum, and steam those areas that bed bugs are likely to be. This will cut down on the bed bug population while making it harder for survivors to hide.
In the case of beds, a more economical option is to encase both the mattress and box spring in a protective cover like those used for allergy relief. Encasements specifically designed to help protect against bed bugs are available through retail or pest control firms. Higher quality ones tend to be more durable and comfortable to sleep on. Once the encasement is installed and zipped shut, any bugs which happen to be inside are entombed and eventually will die. Encasements also help protect newly purchased beds, and make it easier to spot and destroy any bugs residing on the outer surface during subsequent examination. Encasements will not, however, keep bed bugs from crawling onto a bed and biting a sleeping person.
×