To kill bed bugs is to save yourself from a lot of problems. However, before you could eliminate them, there are several preparatory steps that you first have to take so you will know how to get rid of bed bugs. With all those problems and pre-elimination work, many think it is better to prevent the pests by using bed bug spray than to let them in and just get rid of them.
Systematically treat the room–all cracks and crevices around windows, outlets, blinds, pictures, posters and clocks on walls, baseboards, under edges of carpets and any other crevices or void areas in the room. Remember that immature bed bugs are very tiny. Dozens of bed bugs can hide in a recessed screw hole in a bed frame or dresser. Therefore it’s important that no hiding place be overlooked. Treatment can include vacuuming, but should not be limited to vacuuming only. Vacuums do not remove eggs, and will likely not remove all bed bugs from deeply infested cracks and crevices. Vacuums can remove many bed bugs from mattresses and the exterior of box springs (remember to immediately double-bag the vacuum bag after cleaning and dispose of outside in a trash can or dumpster). Sticky tape is another method of picking up bed bugs from furniture, walls, etc.
Dismantling bed frames in infested areas typically exposes bed bug hiding sites. Having access to these areas during cleaning is important. Stand up the box spring and shine a flashlight through the gauze fabric and look for bed bugs. If the fabric is torn (possible hiding place), remove fabric to prepare for spraying. If the mattress and or box springs are infested, you may want to consider Encasements by Mattress Safe. Once covered with these encasements, bed bugs can not enter or exit. There is no need to treat the mattress or box spring when using these encasements. Keep them on for a year.
Insecticides might also have their work cut out for them: Entomologists have known that the common bedbug has built up resistance to some typical insecticides such as those containing certain pyrethroid chemicals like deltamethrin, according to Entomology Today. Deltamethrin apparently paralyzes an insect's nervous system, according to Cornell University.
Discard affected items. In some cases, infested mattresses and box springs will need to be discarded. Since bed bugs can disperse throughout a building, it also may be necessary to inspect adjoining rooms and apartments. Pay it forward: chop up and/or damage the items you discard so nobody will be tempted to take them home and spread the problem further.
Bring in only what is needed, and avoid sitting or placing coats and other items on beds, floors and sofas where the bugs commonly reside. Essential items can be placed on a tabletop or other hard surface, preferably away from bedrooms and sleeping areas. Better to sit on a hard (non-upholstered) chair than on sofas and recliners. Also try to avoid leaning or brushing against beds and upholstered furniture. If such items are carried out of infested dwellings (e.g., by sanitation workers or firefighters), it’s best to wrap them in plastic or at least not hold them against your body during transport. Emergency Medical (EMS) personnel may need to take additional precautions, such as removing a patient’s bed bug-infested shoes or clothing, or installing plastic sheeting before transporting them in the emergency vehicle.
You should look for traces of the insects in the folds of your mattresses, box springs and other places where they are likely to hide. You might be able to find their papery skins, which get cast off after molting and look like popcorn kernels but are smaller and thinner, Harlan said. They also leave small, dark-colored spots from the blood-filled droppings they deposit on mattresses and furniture. If you can touch the spot with a water-soaked towel and it runs a rusty, reddish color, you're probably looking at a fresh drop of bedbug feces, Harlan said.
When you finish, throw out the vacuum bag to avoid spreading the bugs. If you use a shop vacuum or bagless vacuum, dump the contents you’ve collected into a bag, tie it up, and throw it out. And treat the filter and the inside of the canister with contact spray insecticide. Flat surfaces like walls and dresser tops can be wiped with alcohol. Wipe a small inconspicuous area first to see if the alcohol will damage the paint or finish.
Killing all bed bugs on your bed frame and headboard. Normally this would be done by a pest control professional. Approximately 70% of all bed bugs in the typical infestation are located on the mattress, box spring and bed frame. You’ve encased the mattress and box spring and taken care of that problem. Now you have to make sure that your bed frame is bed bug free. Vacuuming alone won’t do this. Vacuuming can remove many bed bug adults and nymphs, but it isn’t very good at removing eggs. For this job you’ll need insecticide sprays and possibly dusts to treat every crevice and void in your bed. For insecticide spray and dust options see below. Remember that insecticides can be hazardous if you don’t follow label directions. Read the whole label before spraying or dusting. The label directions are the law and failure to follow the label not only puts you and your family at risk, it is against the law. Homemade sprays, by the way, are usually less safe than commercial insecticides. Stick with the legal stuff.
Flat surfaces can be wiped with alcohol or sprayed with a bed bug—killing contact pesticide, but all items that have a small nook or cranny where bed bugs could hide (which is most stuff) need to be treated with penetrating fumes. Build yourself a kill chamber out of a large storage bin. Tape a pesticide strip to the side or lid of the bin, and seal your stuff inside for a couple days or however long the manufacturer recommends. Seal the lid of the bin with duct tape.
Bed bugs are attracted to their hosts primarily by carbon dioxide, secondarily by warmth, and also by certain chemicals. Cimex lectularius only feeds every five to seven days, which suggests that it does not spend the majority of its life searching for a host. When a bed bug is starved, it leaves its shelter and searches for a host. It returns to its shelter after successful feeding or if it encounters exposure to light. Cimex lectularius aggregate under all life stages and mating conditions. Bed bugs may choose to aggregate because of predation, resistance to desiccation, and more opportunities to find a mate. Airborne pheromones are responsible for aggregations.
Bedbugs are parasitic arthropods from the family Cimicidae. They are typically less than 1 cm in length and reddish brown in color. Bedbugs can be found in furniture, floorboards, peeling paint, or other small spaces, most commonly in areas of clutter. These insects come out at night in search of prey upon which to feed, with peak feeding times just before dawn. Bedbugs are typically attracted to body heat, carbon dioxide, vibration, sweat, and odor. The image of a Cimex lectularius is shown courtesy of the US Centers for Disease Control and Prevention (CDC).
Start with the bed, including mattress, box-spring and bed frame. Inspect the visible areas first. Look along all edges and corners. Also check along all stitch lines and the mattress label. Five sides the mattress can be checked while the mattress is on the bed. When you are finished checking the upper surfaces, you can then stand the mattress upright so you can check the bottom of the mattress.
Bed bug bites: What you need to know Bed bugs are small, parasitic insects that feed on human blood. They often bite humans during the night or early morning when people are asleep. While they don't carry disease, they can cause irritation, sores, and itchiness that might prevent a good night's sleep. Learn how to identify, control, and prevent bed bugs. Read now